LAPSE:2023.23767
Published Article

LAPSE:2023.23767
Waste to Energy: Solid Fuel Production from Biogas Plant Digestate and Sewage Sludge by Torrefaction-Process Kinetics, Fuel Properties, and Energy Balance
March 27, 2023
Abstract
Sustainable solutions are needed to manage increased energy demand and waste generation. Renewable energy production from abundant sewage sludge (SS) and digestate (D) from biogas is feasible. Concerns about feedstock contamination (heavy metals, pharmaceuticals, antibiotics, and antibiotic-resistant bacteria) in SS and D limits the use (e.g., agricultural) of these carbon-rich resources. Low temperature thermal conversion that results in carbonized solid fuel (CSF) has been proposed as sustainable waste utilization. The aim of the research was to investigate the feasibility of CSF production from SS and D via torrefaction. The CSF was produced at 200~300 °C (interval of 20 °C) for 20~60 min (interval 20 min). The torrefaction kinetics and CSF fuel properties were determined. Next, the differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) of SS and D torrefaction were used to build models of energy demand for torrefaction. Finally, the evaluation of the energy balance of CSF production from SS and D was completed. The results showed that torrefaction improved the D-derived CSF’s higher heating value (HHV) up to 11% (p < 0.05), whereas no significant HHV changes for SS were observed. The torrefied D had the highest HHV of 20 MJ∙kg−1 under 300 °C and 30 min, (the curve fitted value from the measured time periods) compared to HHV = 18 MJ∙kg−1 for unprocessed D. The torrefied SS had the highest HHV = 14.8 MJ∙kg−1 under 200 °C and 20 min, compared to HHV 14.6 MJ∙kg−1 for raw SS. An unwanted result of the torrefaction was an increase in ash content in CSF, up to 40% and 22% for SS and D, respectively. The developed model showed that the torrefaction of dry SS and D could be energetically self-sufficient. Generating CSF with the highest HHV requires raw feedstock containing ~15.4 and 45.9 MJ∙kg−1 for SS and D, respectively (assuming that part of feedstock is a source of energy for the process). The results suggest that there is a potential to convert biogas D to CSF to provide renewable fuel for, e.g., plants currently fed/co-fed with municipal solid waste.
Sustainable solutions are needed to manage increased energy demand and waste generation. Renewable energy production from abundant sewage sludge (SS) and digestate (D) from biogas is feasible. Concerns about feedstock contamination (heavy metals, pharmaceuticals, antibiotics, and antibiotic-resistant bacteria) in SS and D limits the use (e.g., agricultural) of these carbon-rich resources. Low temperature thermal conversion that results in carbonized solid fuel (CSF) has been proposed as sustainable waste utilization. The aim of the research was to investigate the feasibility of CSF production from SS and D via torrefaction. The CSF was produced at 200~300 °C (interval of 20 °C) for 20~60 min (interval 20 min). The torrefaction kinetics and CSF fuel properties were determined. Next, the differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) of SS and D torrefaction were used to build models of energy demand for torrefaction. Finally, the evaluation of the energy balance of CSF production from SS and D was completed. The results showed that torrefaction improved the D-derived CSF’s higher heating value (HHV) up to 11% (p < 0.05), whereas no significant HHV changes for SS were observed. The torrefied D had the highest HHV of 20 MJ∙kg−1 under 300 °C and 30 min, (the curve fitted value from the measured time periods) compared to HHV = 18 MJ∙kg−1 for unprocessed D. The torrefied SS had the highest HHV = 14.8 MJ∙kg−1 under 200 °C and 20 min, compared to HHV 14.6 MJ∙kg−1 for raw SS. An unwanted result of the torrefaction was an increase in ash content in CSF, up to 40% and 22% for SS and D, respectively. The developed model showed that the torrefaction of dry SS and D could be energetically self-sufficient. Generating CSF with the highest HHV requires raw feedstock containing ~15.4 and 45.9 MJ∙kg−1 for SS and D, respectively (assuming that part of feedstock is a source of energy for the process). The results suggest that there is a potential to convert biogas D to CSF to provide renewable fuel for, e.g., plants currently fed/co-fed with municipal solid waste.
Record ID
Keywords
biogas digestate, carbonized solid fuel, circular economy, Renewable and Sustainable Energy, sewage sludge, Sustainability, waste to carbon, waste to energy
Subject
Suggested Citation
Świechowski K, Hnat M, Stępień P, Stegenta-Dąbrowska S, Kugler S, Koziel JA, Białowiec A. Waste to Energy: Solid Fuel Production from Biogas Plant Digestate and Sewage Sludge by Torrefaction-Process Kinetics, Fuel Properties, and Energy Balance. (2023). LAPSE:2023.23767
Author Affiliations
Świechowski K: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland [ORCID]
Hnat M: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland
Stępień P: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland [ORCID]
Stegenta-Dąbrowska S: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland [ORCID]
Kugler S: Faculty of Chemical Technology and Engineering, Polymer Institute, West Pomeranian University of Technology, 10 Pułaskiego Str., 70-322 Szczecin, Poland [ORCID]
Koziel JA: Department of Agricultural and Biosystems Engineering, Iowa State University, Ames, IA 50011, USA [ORCID]
Białowiec A: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland; Department of Agricultural and Biosystems Engineering, Iowa State [ORCID]
Hnat M: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland
Stępień P: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland [ORCID]
Stegenta-Dąbrowska S: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland [ORCID]
Kugler S: Faculty of Chemical Technology and Engineering, Polymer Institute, West Pomeranian University of Technology, 10 Pułaskiego Str., 70-322 Szczecin, Poland [ORCID]
Koziel JA: Department of Agricultural and Biosystems Engineering, Iowa State University, Ames, IA 50011, USA [ORCID]
Białowiec A: Faculty of Life Sciences and Technology, Institute of Agricultural Engineering, Wrocław University of Environmental and Life Sciences, 37/41 Chełmońskiego Str., 51-630 Wrocław, Poland; Department of Agricultural and Biosystems Engineering, Iowa State [ORCID]
Journal Name
Energies
Volume
13
Issue
12
Article Number
E3161
Year
2020
Publication Date
2020-06-18
ISSN
1996-1073
Version Comments
Original Submission
Other Meta
PII: en13123161, Publication Type: Journal Article
Record Map
Published Article

LAPSE:2023.23767
This Record
External Link

https://doi.org/10.3390/en13123161
Publisher Version
Download
Meta
Record Statistics
Record Views
365
Version History
[v1] (Original Submission)
Mar 27, 2023
Verified by curator on
Mar 27, 2023
This Version Number
v1
Citations
Most Recent
This Version
URL Here
https://psecommunity.org/LAPSE:2023.23767
Record Owner
Auto Uploader for LAPSE
Links to Related Works
(0.61 seconds) 0.05 + 0.02 + 0.22 + 0.1 + 0.01 + 0.06 + 0.07 + 0 + 0.03 + 0.05 + 0 + 0.01
