Designing a Smart Gateway for Data Fusion Implementation in a Distributed Electronic System Used in Automotive Industry

Mircea Rîșteiu; Remus Dobra; Alexandru Avram; Florin Samoilă; Georgeta Buică; Renato Rizzo; Dan Doru Micu

LAPSE

Living Archive for Process Systems Engineering

LAPSE:2023.32749

Published Article

LAPSE:2023.32749

Designing a Smart Gateway for Data Fusion Implementation in a Distributed Electronic System Used in Automotive Industry

Mircea Rîșteiu, Remus Dobra, Alexandru Avram, Florin Samoilă, Georgeta Buică, Renato Rizzo, Dan Doru Micu

April 20, 2023

This paper focuses on the interdisciplinary research on the design of a smart gateway for managing the dynamic error code testing collected and generated by the Electronic Control Unit (ECU) from the automotive industry. The techniques used to exchange information between the ECU code errors and knowledge bases, based on data fusion methods, allowed us to consolidate and ensure data reliability, and then to optimize processed data in our distributed electronic systems, as the basic state for Industry 4.0 standards. At the same time, they offered optimized data packets when the gateway was tested as a service integrator for ECU maintenance. The embedded programming solutions offered us safe, reliable, and flexible data packet management results on both communication systems (Transmission Control Protocol/Internet Provider (TCP/IP) and Controller Area Network (CAN) Bus) on the Electronic Control Unit (ECU) tested for diesel, high-pressure common rail engines. The main goal of this paper is to provide a solution for a smart, hardware−software, Industry-4.0-ready gateway applicable in the automotive industry.

Record ID

LAPSE:2023.32749

Keywords

Big Data, data compatibility, data-fusion-ready, distributed electronic circuit testing, embedded programming, Industry-4.0-ready, intelligent decision support, on-board diagnostics interface, predictive and automated service

Subject

Process Control

Suggested Citation

Rîșteiu M, Dobra R, Avram A, Samoilă F, Buică G, Rizzo R, Micu DD. Designing a Smart Gateway for Data Fusion Implementation in a Distributed Electronic System Used in Automotive Industry. (2023). LAPSE:2023.32749

Author Affiliations

Rîșteiu M: Department of Computer Science and Engineering, Faculty of Exact Sciences and Engineering, “1 Decembrie 1918” University of Alba Iulia, Gabriel Bethlen, 510009 Alba-Iulia, Romania
Dobra R: Department of Computer Science and Engineering, Faculty of Exact Sciences and Engineering, “1 Decembrie 1918” University of Alba Iulia, Gabriel Bethlen, 510009 Alba-Iulia, Romania
Avram A: Department of Computer Science and Engineering, Faculty of Exact Sciences and Engineering, “1 Decembrie 1918” University of Alba Iulia, Gabriel Bethlen, 510009 Alba-Iulia, Romania
Samoilă F: Department of Computer Science and Engineering, Faculty of Exact Sciences and Engineering, “1 Decembrie 1918” University of Alba Iulia, Gabriel Bethlen, 510009 Alba-Iulia, Romania
Buică G: “Alexandru Darabont” National Research and Development Institute of Occupational Safety (INCDPM), Ghencea 35, 061692 Bucharest, Romania
Rizzo R: Department of Electrical Engineering and Information Technologies, University of Naples Federico II, 80138 Naples, Italy
Micu DD: Department of Electrical Engineering, Technical University of Cluj-Napoca, 400114 Cluj-Napoca, Romania [ORCID]

Journal Name

Energies

Volume

14

Issue

11

First Page

3300

Year

2021

Publication Date

2021-06-04