Abstract
A control system for a piezoelectric beam actuator, which had one or two control inputs, was a subject of numerical and laboratory research. The actuator had a prismatic shape with a rectangular cross-section and consisted of one layer of carrying substrate made from PCB-FR4 and two patches of Macro Fiber Composite of P1 type. MFC patches were glued on both sides of the carrying substrate. An article presents a comparison of the control quality of piezoelectric actuator with one control signal (one-input actuator) and the control quality of piezoelectric actuator with two control signals (two-input actuator). An application of two-input actuator led to a reduction of control voltage compared to the control voltage of one-input actuator. The decrease in the maximum voltage was approximately from 30% to 39% in conducted laboratory experiments. An application of two-input actuator causes a reduction of an overshoot value compared to one-input actuator. An application of limit of maximum control voltage leads to a greater decrease of the control quality for one-input actuator compared to two-input actuator.