Abstract
This paper proposes a method to improve the output torque of a six-phase permanent-magnet synchronous machine (PMSM) within the same current peak limit through a fifth-harmonic injection into each phase current of the stator. Compared to the fifth + seventh-harmonic current-injection method used to improve the output torque of the six-phase PMSM, the control system can be stably controlled, and the controller design complexity decreased. This is because the harmonic component was converted into a direct current (DC) component and controlled by a proportional-integral (PI) controller instead of the fifth + seventh-harmonic injection method, which converts the harmonic component into an alternating current (AC) component and controls it with a resonance controller. The appropriate fifth-harmonic ratio for maximum output torque through fifth-harmonic injection was selected through optimization using values analyzed via fast Fourier transform (FFT) for stator phase harmonic current terms caused by inverter nonlinearity and motor design errors. Therefore, it was possible to optimize the fifth-harmonic ratio to be injected without requiring torque modeling using the physical properties of the motor. The experimental results were obtained under the rated current condition with six-phase PMSM in the laboratory, and the average output torque increase under fifth-harmonic injection was about 5% compared to the method without harmonic injection.