Abstract
In order to exchange the wood biomass energy for electric power with small capacity and high efficiency, it is most effective to use a reciprocating engine operated with a wood gasifier. On the other hand, such a small-capacity system is often installed in urban areas. Therefore, strict emission regulation should be observed. Normally, as the low heating value (LHV) of bio-syngas is small, the engine should be operated with a stoichiometric mixture to achieve a maximum power density. However, the emission with a stoichiometric mixture contains much unburned CO. This means that a stoichiometric mixture operation shows low efficiency and can’t observe the regulations. In this report, a mechanism of the unburned CO is considered, and a method to reduce the unburned CO ratio is shown with experimental results. In the experiment, a commercial reciprocating engine (4-stroke, modified single cylinder) is used. The bio-syngas, a producer gas from a fixed bed gasifier, is produced by a self-made wood pellet gasifier (fixed bed, auto thermal down-draft). The bio-syngas flow rate is calculated with the nitrogen ratio between input air and bio-syngas. The LHV is adjusted with the city gas (as an alternative to methane) and hydrogen. The CO volume ratio of the exhaust from the engine is more than 3 v% when the excess air ratio of bio-syngas/air mixture is 1.3, as the LHV of bio-syngas is less than 5.0 MJ/m3-LHV. On the other hand, the CO volume ratio of the exhaust under operation of the mixture, the bio-syngas, and methane with more than 7.0 MJ/m3-LHV was less than 0.2 v%. The CO in the exhaust with low LHV fuel means that the combustion is not finished in the chamber. The unburned ratio could be predicted in consideration of the gap/clearance as crevice, the temperature boundary layer, and the quenching distance.