Abstract
The paper deals with finding power system nodes where reactive powers have the greatest influence on system voltages. The problem to be solved is important in reactive power planning. Its proper solution indicates in which nodes new sources of reactive power should be installed in order to achieve the assumed goals in the aforementioned planning. So far, the problem formulated earlier has not been satisfactorily resolved. The paper presents an original method, which, based on the entire history of the system operation states, allows a solution to the problem mentioned above to be found. The proposed method assumes the use of measurement data of nodal-voltage magnitudes and nodal reactive power. Correlational relationships between the above-mentioned quantities are investigated. The paper shows that the considered correlational relationships are not linear. In this situation, Kendall’s rank correlation coefficient is used to evaluate the strength of these correlational relationships. Analysis of the strongest relationships allows us to identify those nodal reactive powers that have the greatest influence on the voltages in the power system. The results of the analysis are the basis for determining the location of additional reactive power sources in the power system, which is very essential in reactive power planning. The proposed method is relatively easy to implement and does not require complicated calculations. The paper additionally shows that failure to use the entire spectrum of representative system states when solving the problem under consideration can adversely affect the result.